Institution
Saint Petersburg Mining University
Recent research
- Engineering & Technology
Optimization of cutter geometry for deep milling of stump-containing peat deposit
This paper presents an experiment-based justification of rational geometric parameters for cutting elements of machines designed for deep milling of stump-containing peat deposits. A key challenge in this process is the presence of buried wood with the moisture content up to 64%,...
- Materials & EnergyOpen access
Economic and institutional drivers of renewable energy adoption: A cross-country panel analysis
This article identifies the economic and institutional factors driving cross-country differences in renewable energy adoption, focusing on solar and wind power. Unlike previous studies that either compare the share of renewable energy sources or analyze individual support policie...
- Engineering & TechnologyOpen access
This study examines extracurricular participation within a broader conceptual view of the academic community as an environment for the professional formation of engineering students. We conducted a quantitative cross-sectional survey of 898 engineering and technical students at E...
- Engineering & TechnologyOpen access
Waveform Analysis of Non-Sinusoidal Electrical Signals Using Cubic Spline Interpolation
The steady increase in nonlinear loads in modern electric power systems leads to distortion of electrical signal waveforms and, consequently, to deterioration of power quality. The presence of higher harmonics in the network adversely affects electrical equipment, especially capa...
- Engineering & TechnologyOpen access
This study focuses on developing a method for utilizing phosphogypsum, a large-tonnage waste product from phosphate raw material processing, whose disposal sites are sources of complex negative impacts on the environment. As a promising approach to the utilization of gypsum-conta...
- Engineering & TechnologyOpen access
In this work, the load-dependent indentation response of as-built Inconel 718 produced by direct laser deposition was studied, followed by local mapping around a single surface-intersecting pore. A working load of 100 mN was selected because the indentation modulus approached a d...
- Engineering & TechnologyOpen access
This study investigates ground deformation affecting fuel-storage tanks TK-5 and TK-6 at Moa Port, Cuba, a coastal facility built on reclaimed ground. The analysis integrates Interferometric Synthetic Aperture Radar (InSAR), engineering-geological interpretation of borehole data,...
Proceedings of the Institution of Civil Engineers - Geotechnical Engineering2026-09-180 citationsDOI - Engineering & TechnologyOpen access
As the share of nonlinear loads in the power supply systems of industrial enterprises increases, the importance of accurately estimating higher harmonics through modeling grows both in operation and in design. In this case, all network elements and loads are represented by their...
- Engineering & TechnologyOpen access
This article presents an experimental study of the effect of chromium (III) oxide, recovered from chromium-containing catalyst sludge, on the properties of grouting mortars used for well cementing in permafrost zones. The necessity of modifying grouting mortars to increase the st...
Journal of Mining Institute2026-08-310 citations - BiologyOpen access
Исследование «колчеданского янтаря» с помощью ИК-спектроскопии
This work is devoted to the study of fossil resins from the collection of the Mining Museum using infrared spectroscopy (FTIR). Samples of amber from the Iset River in the Middle Urals, collected in the early 19th century and known as “Kolchedan amber”, were examined. For compari...
- Engineering & TechnologyOpen access
This research investigates the operational performance of ejection systems integrated into drilling rock-breaking assemblies. The object of the study is a near-bit reaming-ejection device (RED), which is installed in the bottom hole assembly (BHA) and is intended to improve botto...
Journal of Mining Institute2026-08-310 citations - Materials & EnergyOpen access
Metallurgical R&D search is difficult for a practical reason: useful evidence is rarely defined by one keyword. A production-support question can depend at the same time on material grade, process route, defect mechanism, property, test method, and numerical conditions. Conventio...